Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
i'm trying to rough using volume, but the tool is invading (within green square in picture attached) the only way i know is to change the model but i don't want to do that because i will have a few problems, i would like to know if anybody knows another way for the nc sequence recognize a surface or anything else as part.
Hi bambi! Try to add the fixture surfaces as check surfaces...or use a mill window to limit the tool so that it won't cross the boundaries you set... Kct de agulha! Daniel
