cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Why does regenerating garble the additional segments of a paginated table?

spete
4-Participant

Why does regenerating garble the additional segments of a paginated table?

Paginated BOM:

before+regeneration.JPG

Regneration gives this:

after+regeneration.JPG

The only way I can clear up the BOM is to re-set the extent of table. I am new to Creo 2.0; however, I used Wildfire for many years. The issue wasn't something I encountered in Wildfire, but I have noticed that table pagination is a different.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions
TomU
23-Emerald II
(To:spete)

This has been resolved in Creo Parametric 2.0 M130. See SPR 2221135 and article CS170301.

View solution in original post

1 REPLY 1
TomU
23-Emerald II
(To:spete)

This has been resolved in Creo Parametric 2.0 M130. See SPR 2221135 and article CS170301.

View solution in original post

Announcements