Wildfire 4 M092 or M110?

[akelly]

We're going to be updating tomorrow from WF2 / Pro/Intralink 3.4 to WF4 / Pro/Intralink 9.1. We planned on installing WF4 M092 because:
1) M092 fixes a premature exit problem with Pro/Intralink 9.1
2) There has been a lot of complaining on the Exploder about problems w/ M100

M110 is the current build.

Should we install M110 for "go live", or should we stick with M092?

Andrew Kelly, P.E. | Senior Engineer | Crane Aerospace & Electronics | +1 440 326 5555 | F: +1 440 284 1090


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[ZacharyAlexande]

When in doubt, upgrade. In almost every case the newer release is the better
one.

On Tue, Oct 13, 2009 at 7:12 AM, Kelly, Andrew C <
-> wrote:

> We're going to be updating tomorrow from WF2 / Pro/Intralink 3.4 to WF4 /
> Pro/Intralink 9.1. We planned on installing WF4 M092 because:
>
> 1) M092 fixes a premature exit problem with Pro/Intralink 9.1
> 2) There has been a lot of complaining on the Exploder about problems w/
> M100
>
> M110 is the current build.
>
> Should we install M110 for "go live", or should we stick with M092?
>
> Andrew Kelly, P.E. | Senior Engineer | Crane Aerospace & Electronics |+1 440 326 5555
> | F: +1 440 284 1090
>

[STEVEG]

I fully disagree. They probably tested 9.1 with M092 and are satisfied with that. A newer build can introduce other issues. So use M092 for the upgrade and test M100 later. And if you look at past emails on the board you will see there is a measure delay with large assemblies that appeared in M100 per Walter Weiss. There may be other issues too.

Steve G

[TrainStopper]

M110 appears to have fixed the measurement delay, and is working out ok
for me so far, but I do not have Intralink or Windchill.



Regards,

Walt Weiss

[jer3d1]

We have been on WF4 M092 for about two months. No show stoppers here.

WF4 M092 w/Windchill 8 M050

All the best,
Jered