cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Word wrap for string parameters in drawing tables

ShawnPete
1-Newbie

Word wrap for string parameters in drawing tables

When entering string paramenters into tables, the tables can become cumbersome when the string parameter is of significant length.  A way to wrap a parameter, either by a set number of characters, or by a column width would be valuable.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
2 REPLIES 2

Add into this request to also remove the 80 character barrier that exists for all parameters.  There shouldn't be a reason that Creo has a length limitation when PDMLink has the ability to pass much longer pieces of text to Creo.

Text wrapping of string parameter values when the parameters are called out in table cells is supported in Creo 1.0 and later. Just select the table cell and then right-click > Wrap Text.

Top Tags