I have a tolerance of +.0004/-.0000 on a print. The ".0000" does not show on the drawing.
I found a setting for "blank_zero_tolerance" in the drawing detail, but yes/no does not seem to make a difference.
Does anyone know what is wrong?
We are using: Creo 2.0 M20
[Description: Description: Description: Acumed_Logo_200x38] Chad Smith Product Engineer | Sustaining Engineering p: 503.207.1440 www.acumed.net This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.