cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can Bookmark boards, posts or articles that you'd like to access again easily! X

dimension

rmogensen
1-Newbie

dimension

When I try to put a driven diameter dimension in my detail drawing view, it comes in as a radius callout.  Is there a wetting to change this?  If not, How do I change the properties of the hole callout to recognize the diameter instead of the radius?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

Click the same arc twice before placing the dimension and you will get a diameter value.

This is normal behavior for Creo.  Same for sketches.

You can also right click the dimension and change between radial and diameter.

View solution in original post

2 REPLIES 2

Click the same arc twice before placing the dimension and you will get a diameter value.

This is normal behavior for Creo.  Same for sketches.

You can also right click the dimension and change between radial and diameter.

Thanks

Top Tags