dual dimension shows comma instead of a decimal point?

[rohit_rajan]

why does the dual dimension show a comma instead of a decimal?

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[John.Pryal · Accepted solution]

Hi,

try setting the dtl config option "decimal marker" to "period", it is probably set to the default "comma_for_metric_dual", which is why you see a comma.

Regards

John

[rohit_rajan]

thank you very much!

[ptc-4896951]

is it possible to get dual dim in creo 2.0 and also please tell mw the way to sout out the problem .

[Patriot_1776]

Check to see if the ASME standard does not specify a comma instead of a period first if the dwg is being checked to ASME.