extrude and groups

[FrederickWright]

hi once again.

I have a prt made up of various skeckes and extrusions, blends et all.

is it possible to group these and make a pattern.

am in pro eng w5 until i decide to upgrade.

best

f

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[TomD.inPDX]

Yes you can. In fact, it is often recommended.

[FrederickWright]

This is good to know. I tried to find groups in w5 but nothing. Found UDF but couldn't get it to work.

Any chance of a little help, please.

F

[DavorGranic]

Just select all features you wana pattern right click and select group and then pattern it.