cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can subscribe to a forum, label or individual post and receive email notifications when someone posts a new topic or reply. Learn more! X

flatten quilt failed

hhagedorn
6-Contributor

flatten quilt failed

Hello PTC Community,

is there any help about my problem?

I want to create a flatten quilt from a copied surface.

Basically it works, yes.

But if I, for example, insert a rounding or chamfer, the flatten quilt fails.

Are there any ideas or solutions for this?

thx in advance

Heiko

9 REPLIES 9
rohit_rajan
13-Aquamarine
(To:hhagedorn)

Hi Heiko

what you have is a solid.As far as my knowledge flatten quilt will only work with quilt or surface.

hhagedorn
6-Contributor
(To:rohit_rajan)

Hi Rohit,

It is correct that the base KE is a solid.

But the surfaces were still copied to continue using it.

Do i understanding something wrong?

By the way, if you delete the round "ERROR_ROUND" KE-ID 6880, then the flatten quilt works fine. But not with the round.

hhagedorn
6-Contributor
(To:hhagedorn)

It's me again, .....

The problem is even if the construction is a boundary blend and no solid as the base KE.
rohit_rajan
13-Aquamarine
(To:hhagedorn)

sorry for my earlier post as did ot see your part properly.

Yes I believe the round at the corner is the issue.

Right now can't tell why that is so.

ok that round may not be the issue

rohit_rajan
13-Aquamarine
(To:hhagedorn)

I think the issue is the second sketch,which is at an angle to the first sketch.

rohit_rajan
13-Aquamarine
(To:hhagedorn)

I projected the first sketch on the plane and was able to flatten it.I took your boundary blend part and made the modification.

I think flatten quilt cannot handle that angle between the two sketches.

I have attached the modified part.But I did the changes in Creo 3.0 student edition.

rohit_rajan
13-Aquamarine
(To:hhagedorn)

I made the same change to the part in which you have use parallel blend with the round intact and I was able to flatten it.

I have attached that part also.Changes made in Creo 3.0 Student edition.

For your convenience I have attached the step file of the modified part and you can try the flatten quilt yourself.

hhagedorn
6-Contributor
(To:rohit_rajan)

Hello rrajan,

thanks for your efforts and your quick Support.

Unfortunately I need the angular offset between the sketches.

Is there still nobody who has a solution?

Top Tags