formability of a sheetmetal part

[cprakash]

Hello,

I want to know about Pro/Dieface. Its capabilities & usages.

Can I do a formability of a sheetmetal part with Pro/Dieface.

OR

Any solutions to blank a sheetmetal part with 3D profile, usually creo 2.0 or pro/e does not.

Need Help!!!

Thanks.

Chandra Prakash

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[TomD.inPDX]

Hello Chandra and welcome to the forum.

I do not know about the Pro/Dieface extension but you can probably get a 30 day trial from your "value added reseller" (VAR).

I suppose it would all depend on the complexity of the designs you want to do with Creo. In general, you can define a die in many ways for sheetmetal. Usually, the PTC extensions are "packaged" common Creo commands. What exactly are you trying to accomplish? ...and is this best answered by a PTC representative for your particular case?