hole pattern using dimension and relation by increment

[ptc-3123840]

Hello,

how to create hole patterns using dimensions with relations increment,

thanks

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[TomD.inPDX]

Hello Prashant and welcome to the forum.

Can you explain better what you mean by increment?

I am pretty sure the answer is yes, but maybe not as simple as just having an equation to manage the increment.

For instance... if I want a location series of 1,2,4,8,16 unit spacing, I might have to use a pattern based on points. The points will be defined using relations to locate the point in relation to each other.

* -d1=1- * d2=d1*2- * -d3=d2*2- * -d4=d3*2- * (etc...)

[ptc-3123840]

Thanks,

below is the image for your query related to increment for hole patterns,

Message was edited by: Prashant Shinde