i would like to understand the template names when starting a new document

[PG_11980159]

i would like to understand the template names when starting a new document. is there a reference to all the template names (eg mmks_asm.design_abs and all the other variants)

[Bassam.Yazigi]

Here is some information about template names ( Predefined Systems of Units).

There are two Unit Systems:

Mass length time (MLT)

Force length time (FLT)

MLT ( Custom System of Units). If you choose the MLT unit system, then the name will be LengthMassTime. If you choose the FLT unit system, then the name will be LengthForseTime

Here are some useful information about Units in general ( About Units)

There is also the part/assembly type

Finally, absolute tolerance vs relative tolerance (Absolute and Relative Tolerance Settings)

So the template name is as follows

MLT unit system: LengthMassTime_part/Ams Type_abs or rel.

Force length time (FLT): LengthForceTime_part/Ams Type_abs or rel

Regards

Bassam

PTC Help Center

The Help Center provides access to documentation for your application and to other resources such as free tutorials, release enhancements, and toolkit guides.

support.ptc.com

BASSAM YAZIGI

CREO Product Lead

Find a training session today!

ptc.com

[PG_11980159]

ok, i was more so looking for these explanations, mmks, mmns, list goes on

[Michael · Accepted solution]

They are abbreviated 

in = inches 

mm = millimeters 

k = kilogram 

abs = absolute accuracy 

rel = relative accuracy 

n = newtons

s = seconds 

and so on. 

[PG_11980159]

thanks Michael, it seems so obvious now that you have said it, 😀. cheers for the info