Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
Hallo,
why are axis highlighted in model/assemblies by the mouse over feature and datums not?
Thanks, Claus
I see no datum planes in the assembly and if they are not shown, they don't highlight with mouse over.
For the axis, it should be the same, but of course I cannot judge by the picture, whether the axis is shown or not.
Note that behavior of datum features may change, when you use "Set Datum" on them (usually they show on screen, even if datum display is off)