Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
hello all . i hadd plate ,i want to make 3 bends in differient positions.ihad made two but the last can not exexute till i delete the other bend >please help .see attached files
Solved! Go to Solution.
This sequence worked for me:
1
2
3 - bend using "up to end of surface" option
4 - add an extrusion to form a flat section that...
... can be bent (again using the "to end of surface" option)It's definitely not intuitive...
thanks for your help.check the picture
.
thanks friend.but after applying bend 1 and bend 3 the position of bend 2 is flat.look at pic below
.
thanks .i'm trying to do this
Also -I do not honor your friendship. But it is a courtesy
This sequence worked for me:
1
2
3 - bend using "up to end of surface" option
4 - add an extrusion to form a flat section that...
... can be bent (again using the "to end of surface" option)It's definitely not intuitive...
thank you very much for help