question

[pjuvekar]

usually when i use sketcher mode, randomly in between many colour lines appear,  and when i zoom in or zoom out they go but appear again after sometime. is there any way to stop this?

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[MartinHanak]

Hi,

I do not understand what do you want to get from your pictures. Please upload another pictures.

Martin Hanak

[MartinHanak]

... and upload the model, if it is possible.

[pjuvekar]

Hi Martin,

I was able to resolve the issue by applying a taper while extruding. Thanks for your answer, I'm sorry fr not getting back to you earlier as I'm not here often.

Thanks again!

[Mahesh_Sharma]

Hi Purva,

Can share the information about resolving this issue and mark that as correct answer to the post.

[pjuvekar · Accepted solution]

Hi Mahesh,

For sure! I resolved this issue by first creating a rectangular sketch which I placed at a particular angle. Then, I extruded it and added a taper to get the desired design, and then cut it. I will put this as the correct answer!

Thanks again!