section detail drawing

[ptc-4577435]

Hi all,

Please check the attachment

I would like to know how is this done on Pro/E or Creo?

looks like an xray to the part.

Regards

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[s.iyer]

Easy...

Create a planar section that passes throught the center axis of the screw holes.

Now in the plan view, create a Broken section to show the section inside.

The picture below would indicate your requirement.

Message was edited by: Srinivasaniyer. Image inserted