I have an assembly that I wish to basically convert into a part. This is essentially a "purchased" part, "black box" to me. In the past, for smaller, simplerassemblies, I would simply merge allthe parts of the assembly, then step that out and back into a part. In this case, the assembly is complex, and merging parts has proved difficult if not impossible (the usual problem with accuracies and overlapping geometry...). I thought in the past I was able to translate out to a single part, but cannot remember the method.
thanks in advance....
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
