Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X
All,
In NASTRAN/Femap, there is an option to report stresses per the element average, instead of the corner/edge values. Is there a similar way to do this in Creo Simulate?
I regularly run into singularities near constraint edges, and one of our Senior Stress Analysts recommended using this approach. Has anybody done this?
Haven't been able to find an answer online so far, or after clicking though all of the options in the Results window.
thanks,
Erik
(FYI, running Creo 3.0)