cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

The community will undergo maintenance on October 16th at 10:00 PM PDT and will be unavailable for up to one hour.

Bonded contact analysis

ssivan
4-Participant

Bonded contact analysis

Hello,

I am trying to do a FEA on bonded contact model, which I ran with contact before.

Even I tried to implement a bonded contact (componenet to componenet) and changed to bonded in model setup, it is not being detected. During the review geometry option it is not even showing that, which is very strange.

Anyone have solution for this?


Regards

Shinoy


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
3 REPLIES 3
gfraulini
17-Peridot
(To:ssivan)

In my opinion, when you have to do a contact analysis, one way to have a good control on the interfaces is setting the analysis generally free, and set all interfaces between parts after.

This metodology might take much time if you launch a contact analysis on a "big" assembly...but I don't think you launch that kind of analisys on a big assembly.

SylvainA.
4-Participant
(To:ssivan)

Did you remove all contact interfaces ?

ehaenen
4-Participant
(To:ssivan)

Steven

Maybe you should start a new simulation model

(see picture).

When simulate refuses do do what you want, this will let you start over again.

Erik

Announcements


Top Tags