Creo Simulate - Dynamic Analysis - Creo 10

[GS_8530322]

Hi Creo Team,

While performing Dynamic Time analysis should the mass normalization parameter  sim_massnorm_modes in Config.pro be set to 'Yes' or does the Dynamic Time analysis automatically sets the parameter to 'Yes' when running.

Regards,

GS

[remy]

Hi 
By chance did you already go through the Help Center ? 
Here is the description of the option : https://support.ptc.com/help/creo/creo_pma/r12/usascii//index.html#page/simulate/simulate/run_options.html

[GS_8530322]

Hi,

Thank you, I had gone through this document earlier, Am I right in assuming that the sim_massnorm_modes parameter controls both Modal & Dynamic Analysis runs.

Regards,

GS

[remy]

Hi i'm recommend you file a case for confirmation.