cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about the Community Ranking System, a fun gamification element of the PTC Community. X

How can you create a torsional moment diagram with Creo Simulate

ThierryDepyper
6-Contributor

How can you create a torsional moment diagram with Creo Simulate

Hi All,

I would like to create a torsional moment diagram with Creo Simulate. See attached example.

is this possible with Creo Simulate?

Kind regards

Thierry


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
ACCEPTED SOLUTION

Accepted Solutions

Thierry,

Try modeling your problem using beam elements. In my quick example I have a beam made up of 3 similar cross sections, so I can load the middle portion as you show. You will need to constrain the ends to run the analysis. This is not the only way to set this problem up with beams, just a quick method that is pretty straight forward. Once you have run the analysis go into results and under DISPLAY TYPE use the GRAPH feature, which has a sub-category for SHEAR/MOMENT. My example was done in WF5, but Creo Sim should have all the same functionality.

Hope this helps,

Jon

QUICK_BEAM_TEST.jpg

View solution in original post

2 REPLIES 2

Thierry,

Try modeling your problem using beam elements. In my quick example I have a beam made up of 3 similar cross sections, so I can load the middle portion as you show. You will need to constrain the ends to run the analysis. This is not the only way to set this problem up with beams, just a quick method that is pretty straight forward. Once you have run the analysis go into results and under DISPLAY TYPE use the GRAPH feature, which has a sub-category for SHEAR/MOMENT. My example was done in WF5, but Creo Sim should have all the same functionality.

Hope this helps,

Jon

QUICK_BEAM_TEST.jpg

Hi Jon, this certainly helps, thank you!

Announcements


Top Tags