cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Need to share some code when posting a question or reply? Make sure to use the "Insert code sample" menu option. Learn more! X

Mechanism help (summary)

BobFrindt
2-Explorer

Mechanism help (summary)

Thanks to all for your responses. It seems the short answer is to use cam
connections with lift off enabled. I used this and it worked as I had
hoped.

I used Autoselect for cam face #1

I used Autoselect for cam face #2

I set the coefficient of restitution (e) value to 0 which is the min and
to 1 which is the max and the response was identical.
It worked in both cases. This value apparently only effects the analysis,
not the motion.

If you select Enable Liftoff on the Cam-Follower Connection Definition
dialog box, the two cams are allowed to separate and collide during a
dragging operation or an analysis run. The cams do not interpenetrate if
they collide.
If you enable liftoff, you can also define a coefficient of restitution
for your cam-follower connection. This value determines the energy loss
due to the impact when cams collide after separating.


Petter also points out below that there is some additional functionality
that is available on WF 5.0 that will also be helpful.
Thanks again everyone for your help,

Bob Frindt
Sr. Designer
Parker Hannifin Corporation
Parker Aerospace
Gas Turbine Fuel Systems Division
9200 Tyler Boulevard
Mentor, OH 44060 USA
direct (440) 954-8159
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements


Top Tags