cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about the Community Ranking System, a fun gamification element of the PTC Community. X

Sparse Matrix Solver and out of core memory mode.

AM_10402502
3-Visitor

Sparse Matrix Solver and out of core memory mode.

AM_10402502_1-1663608334263.png

 

How can this error be resolved.

1 ACCEPTED SOLUTION

Accepted Solutions

Take a look:

 

1. Article - "Creo Ansys Simulation analysis failed on a specific machine in Creo Parametric": https://www.ptc.com/en/support/article/CS373553 

2. Discussion - "There is not enough memory for the Distributed Sparse Matrix Solver to proceed using the out-of-core": https://forum.ansys.com/forums/topic/there-is-not-enough-memory-for-the-distributed-sparse-matrix-solver-to-proceed-using-the-out-of-core/ 

View solution in original post

2 REPLIES 2

Delete unimportant files and make the free space in the drive (that your working directory is under it) at least 60GB.

 

It was a complex problem always failed my simulations. In the end I found out the root cause was such a simple one: there have to be enough free memory space in the workspace in order to run a simulation.

 

Yesterday I ran 16 simulations overnight, and failed one modal analysis. I found out in the morning that the free memory left in my drive is only 23GB. So I am to delete files or transfer them to outside depository.

Take a look:

 

1. Article - "Creo Ansys Simulation analysis failed on a specific machine in Creo Parametric": https://www.ptc.com/en/support/article/CS373553 

2. Discussion - "There is not enough memory for the Distributed Sparse Matrix Solver to proceed using the out-of-core": https://forum.ansys.com/forums/topic/there-is-not-enough-memory-for-the-distributed-sparse-matrix-solver-to-proceed-using-the-out-of-core/ 

Top Tags