Hi alls,
Sometimes ago, I've seen that it was possible to make some measures on
material samples and then fill results in software.
Then, properties (Young modulus.) were calculated by software.
I can't remember where I've seen this and if it was with Mechanica
(simulate) or Ansys (or an other software).
Does someone see what I mean and can tell me where this can be found?
Thanks,
GB
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
