cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Parts no visable when opening up a assembly?

SOLVED
Newbie

Parts no visable when opening up a assembly?

Hello I am having issues of parts not visible when opening up a assembly in 3.0 . There is a few of my parts not visible in the graphics area however they are in the model tree . There a no simplified reps of this assembly . I can activate the missing part, edit a feature and the part shows up.  I can save the assembly but when I re open it  its missing again. Any ideas ??

Thanks  

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Parts no visable when opening up a assembly?

Rodney,

You may mark appropriate reply to post as correct answer.

17 REPLIES 17
Highlighted

Re: Parts no visable when opening up a assembly?

Hi, it is possible to share your assembly (we can try to investigate your data)

Regards,

Vladimir

Best Regards,
Vladimir Palffy

Re: Parts no visable when opening up a assembly?

Rodney,

I met similar situation in CR3 M020. I used the following procedure to resolve the problem.

  1. I started Creo session
  2. I opened top assembly (for example myasm.asm.22) from original directory
  3. I created backup directory (for example c:\backup)
  4. I applied Backup command on top assembly into backup directory
  5. I ended Creo session
  6. In backup directory I renamed top assembly file (for example from myasm.asm.1 to myasm.asm.23)
  7. I copied renamed top assembly file from backup directory to original directory
  8. I started Creo session and opened top assembly (myasm.asm.23) from original directory ... assembly display was OK

Martin Hanak


Martin Hanák

Re: Parts no visable when opening up a assembly?

Rodney,

What are the results if you change the display style to Wireframe/Hidden Line/No Hidden/Shading after retrieving the assembly?

Re: Parts no visable when opening up a assembly?

Sorry but our company will not allow it .

Thanks

Re: Parts no visable when opening up a assembly?

Thanks I will give that a try .

I just would like to know what causes this problem . I have seen it happen a few time in the past and not sure if it is a software bug or something I am doing incorrect .

Thanks

Re: Parts no visable when opening up a assembly?

I tried that but it seems to make no difference.

Thanks  

Re: Parts no visable when opening up a assembly?

Basic question but I gotta ask...Are the parts hidden or turned off in a layer?

hidden.jpg


Steve Williams
Pro/E Version 15/16 (Circa 1995/1996)

Re: Parts no visable when opening up a assembly?

This part is hidden in the Model Tree 

Regards,

Vladimir

Best Regards,
Vladimir Palffy

Re: Parts no visable when opening up a assembly?

I guess the problem is caused by software bug...


Martin Hanák