Dimensioning Problem

[ayaqoob]

i 'm beginner.. facing a problem regarding dimensions.. they initially appear as

perhaps these are in mm. i want to use inches, i went here they are already in inches.. i changed to others settled them back to this but no avail.. they keep appearing the same way.. i want to work with inches in single digits but when i type in 1,2 thing appear in micro..nd i guess they show 1mm,2mm etc not inches...while by default creo is set to inches.. i 've creo 3.0 M020 educational edition

[MartinHanak · Accepted solution]

Hi,

measure edge of your model to see lenght units.

Martin Hanak

[ayaqoob]

i got that..but what should i do so as to work with smaller values, the lines,arcs etc appear too small.. If i zoom in while working 1st it does not present an appropriate interface plus when i complete an operation nd hit the check mark it switches to normal nd things appear too small.. in short how can i change relation b/w on screen length and actual length?  

[MartinHanak]

Ahmad,

please, next time upload some explaining pictures.

Default display is affected my datum geometry display.

Model without offset datum plane

Model with offset datum plane

Martin Hanak