cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

How to cap a hole easily

ptc-2046590
1-Visitor
1-Visitor
‎Jun 17, 2008 07:40 AM
‎Jun 17, 2008 07:40 AM

How to cap a hole easily

Is there an easy way to cap off holes in ProE 2.0? I’m needing to do this, so I can run simulations in CFdesign. Or is there a better way of doing it? If anyone has any other helpful tips and hints it would be much appreciated.
0 Kudos
Notify Moderator
4 REPLIES 4
ptc-1181807
1-Visitor
1-Visitor
(To:ptc-2046590)
‎Jun 17, 2008 04:36 PM
‎Jun 17, 2008 04:36 PM

Supress them if possible.
0 Kudos
Notify Moderator
ptc-2046590
1-Visitor
1-Visitor
(To:ptc-1181807)
‎Jun 18, 2008 04:43 AM
‎Jun 18, 2008 04:43 AM

what does that acutually do, as it doesn't give a good discrition in the help section
0 Kudos
Notify Moderator
ptc-2046590
1-Visitor
1-Visitor
(To:ptc-2046590)
‎Jun 18, 2008 07:46 AM
‎Jun 18, 2008 07:46 AM

just tried that and it just hides the holes and doen't end cup (or fill them in)
0 Kudos
Notify Moderator
JoeVarghese
7-Bedrock
7-Bedrock
(To:ptc-2046590)
‎Jun 20, 2008 10:22 AM
‎Jun 20, 2008 10:22 AM

Suppress is like temporarily removing. If you really want that but with a cap, u need to create a surface. One option is to do a sketch at the plane where u want it to be closed. then fill that sketch with surface (Select the sketch and go to Edit -> Fill). Does that serve ur purpose ? Regards Joe
0 Kudos
Notify Moderator
Announcements
Business Continuity with Creo: Learn more about it here.

Top Tags