How to cap a hole easily

[ptc-2046590]

Is there an easy way to cap off holes in ProE 2.0? I’m needing to do this, so I can run simulations in CFdesign. Or is there a better way of doing it? If anyone has any other helpful tips and hints it would be much appreciated.

[ptc-1181807]

Supress them if possible.

[ptc-2046590]

what does that acutually do, as it doesn't give a good discrition in the help section

[ptc-2046590]

just tried that and it just hides the holes and doen't end cup (or fill them in)

[JoeVarghese]

Suppress is like temporarily removing. If you really want that but with a cap, u need to create a surface. One option is to do a sketch at the plane where u want it to be closed. then fill that sketch with surface (Select the sketch and go to Edit -> Fill). Does that serve ur purpose ? Regards Joe