Hi All,
I'm a long time user of the old PTCUser Exploder and have been a little slow in becoming active in the new Communtiy forum. Also my job had become a lot less technical the last couple years. Either way, I'm back. As I'm looking around I see this Customization group, and the Automation group both contain toolkit/programming questions, and then under PTC Creo there is a Pro/Toolkit category as well. All three seem to contain TK threads. Is there a"best" place for the toolkit questions?
THis is the official replacement for the customization exploder.
Due to the merger, it seems we have some duplicate or overlapping subcommunities.
Under the original PTC Community structure, the Pro/Toolkit category probably was the right address, but I'd prefer a subcommunity as the types of questions are quite different and the members participating probably too.
But for the (intended) difference between Automation and Customization, I am clueless. In fact I had asked community management about the purpose of the Automation subcommunity or whether it should be better merged with Customization and noone could give me an answer. So it was decided to run it as is and observe whether it will be used at all. In the beginning it looked like nobody used it, but recently the posts have increased there.