Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hello,
In Kepware ( KepServer Ex 6 server configuration ) what is the suggested Device level scan mode? What settings are appropriate to scan 1000s of tags under each device ?
For example , In our production system I observed that "Respect Client Specified Scan Rate" scan mode some opc tags are bad eventhough they are good on the source server side . After changing to " Request all data at Scan Rate", most opc tags quality went from bad to good .
What are the pros and cons of the above settings on overall impact
Solved! Go to Solution.
Greetings!
Please refer the given article for complete details.
https://www.ptc.com/en/support/article/CS278351
Regards,
Mohit
Greetings!
Please refer the given article for complete details.
https://www.ptc.com/en/support/article/CS278351
Regards,
Mohit