How to read FANUC registers from #10000 address with KEPServerEx?

[AB_10607533]

Hey guys !

I know this question has already been asked but no answer was given.

I am using the KEPServerEx V6 and I want to read values from #10000 and beyond (there is no letter at the beginning, just #) via the Fanuc FOCAS com. protocol. When I try to do so, I am getting the error :
 "Address '#10095' is out of range for the specified device or memory type."

There is nothing for that range of addresses in the appended pdf. 

Thank you !

[cmorehead · Accepted solution]

@AB_10607533 

Please take a look at the page in the manual in the following link which covers acceptable addressing with Fanuc Focus driver:

https://www.ptc.com/store/-/media/kepware-store/en/manuals/fanuc-focas-ethernet-manual.pdf#page=37

When choosing "Open" for the "model" selection" in the device properties; you can reach addresses up to 32767. I presume you have chosen any of the other models in the device properties which allows a max address of 9999 for custom addresses. 

Thanks,

*Chris