Creo cabling

[panand-2]

I am using Creo Parametric - Release 2.0 (connected) 2.0 M250

Harness Bundling Failure and Not able to identify the failure Reason "The wire has more than 0ne disjoint". Need help to resolve this issue and want to know how many wires can be Bundle/routed in a single harness model.

Here are the errors that I faced
The wire has more than 0ne disjoint

[VladimirN]

 Hi,

Take a look at the following articles:

• "If a cable is routed through a splice, the locations on the two ports are highlighted as disjoint when routing in Creo Parametric": https://www.ptc.com/en/support/article/CS161833
• "How to connect separate segments of the same cable or wire in Creo Elements/Pro 5.0 or later": https://www.ptc.com/en/support/article/CS98084