cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can Bookmark boards, posts or articles that you'd like to access again easily! X

EMX part Size calculation issue

ICAD_Support
14-Alexandrite

EMX part Size calculation issue

Hello Community,

 

I am adding an inclined part in EMX Assembly by top-down process.

Part getting added in assembly successfully, but while generating BOM the size calculated by system is rectangular even part is like pin (Circular).

(Actual Size : Dia50 x 300mm - Calculated size: 258 x 258 x80)

Similarly  I am assembled a rectangular plate in inclined way by topdown process, wrong size calculated.

(Actual Size : 408x 70x 28.3 mm - Calculated size: 408 x 68 x61)

 

Please find the attached screen shots.

I used standard Demo data set for trial of EMX assembly.

 

Looking for response.

ACCEPTED SOLUTION

Accepted Solutions
pnos
12-Amethyst
(To:ICAD_Support)

You must make a new axial cross in the model.And to mark it see picture.The parts that are formed in the assembly at an angle do it that way.

View solution in original post

2 REPLIES 2
pnos
12-Amethyst
(To:ICAD_Support)

You must make a new axial cross in the model.And to mark it see picture.The parts that are formed in the assembly at an angle do it that way.

ICAD_Support
14-Alexandrite
(To:pnos)

Thanks for the Solution..!!

Its Working..

Announcements


Top Tags