Process information..
Jan 06, 2011
04:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jan 06, 2011
04:58 AM
Process information..
Hey Guys..
When i create a process dokument for our millingmachines , i use the "&mfg.oper.ncseq.z_min" parameter.
For 5ax milling i will like to output the "z_min" from the seq csys instead of the oper csys ?
I´ve tried remove and replace "oper" but all whitout luck 😞
Jesper
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
3 REPLIES 3
Jan 06, 2011
02:12 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jan 06, 2011
02:12 PM
Try using
&mfg.actoper.ncseq.z_min
or
&mfg.actoper.ncseq.csys
Jan 07, 2011
01:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jan 07, 2011
01:15 AM
Thanks a lot..
I´ve tried both , with no luck.
Any other suggestions ?
Jan 07, 2011
08:41 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jan 07, 2011
08:41 AM
It looks like the tool travel envelope
X_MIN
X_MAX
Y_MIN
Y_MAX
Z_MIN
Z_MAX
is always computed from the MACH CSYS. perhaps there is a way create a user defined pararmeter that could extract the value you want. PTC support could help with that.
