Text engraving
Mar 17, 2010
05:23 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Mar 17, 2010
05:23 PM
Text engraving
I need an engraving font that a small end mill can accually mill. All of the supplied fonts have square corners or an uncontrollable width. My machinist would like to use a 60 degree single point engraving mill, but sketched lettering can not be exported in ether IGES or ACIS. Is there something that I am missing?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
1 REPLY 1
Mar 22, 2010
12:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Mar 22, 2010
12:03 AM
Sketched lettering can be exported via STEP by checking the 'Datum Curves' option during export. IGES should have the same function.
