Turn-Grooving Tools

[mdenicola]

Is there a kind soul out there who would like to help me set up the turn-grooving tools?

Can't find out how to setup TIP, OFFSET CENTER and so on.
Thanks

[VladimirN]

From "Help Center" - "Groove Turning": https://support.ptc.com/help/creo/creo_pma/r9.0/usascii/index.html#page/manufacturing/nc/groove_turning.html

[mdenicola]

Yes , That's the explanation but to me it's still not clear how to set everything.

Let's show an example.

This is my settings:

 The TIP csys is at the center. Nose radius is ( 0.2 mm) 

Insert Width is 4.1

Nose Radius is 0.2

Let's say I need to cut this:

 Should I make a profile at 4.1 mm distance from the part ?

Like this:

Material direction to remove:

 

offset cut checked like this:?

 How to set the OUTPUT_POINT in the parameters dialog box?

 

Thank You!