Installing Mathcad prime 8 stops after "exctracting"
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Installing Mathcad prime 8 stops after "exctracting"
I can't install Mathcad Prime 8. I have alredy Prime 7 (with watermark) and it works good.
I can download the installer but when i launch "pim_installmgr_mathcad.exe" the installation process just stops after "extracting" window reaches 100%, and there are no installer window open after that.
I have tried it many times and as administrator, but always same problem.
Solved! Go to Solution.
- Labels:
-
Installation
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Try the following link: https://alfasoft.science/en/shop/mathematics/mathcad-prime-8-trial/
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
See if this link helps;
https://community.ptc.com/t5/Mathcad-Installation/Mathcad-prime-8-can-t-install/m-p/791076#M1676
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
There was exactly same "pim_installmgr_mathcad.exe" found from that discussion.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Run "PrimeWixinstaller_64bit.msi" from the "ptcsh0" folder of installer.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
I can't exctract the "pim_installmgr_mathcad.exe" so I can't find that file.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Try the following link: https://alfasoft.science/en/shop/mathematics/mathcad-prime-8-trial/
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Thanks a lot! This worked for me!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
You're welcome.