Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hello , new in MATHCAD ( today since 5 houres now), I've a small problem.
As you can see in "test2.mcdx" , I did something wrong but cann't find out what ?
Can someone help me on the right track ?
Marco , France
Thank you all
Solved! Go to Solution.
Mathcad works top to bottom, and left to right. Everything must be defined in the right sequence. So you can't set 'rc' until R and C are defined (move them above).
And RC is not the same as R*C.
And don't define H(jw) like that. You're creating a function of jw but there is no jw there. Just call it H or H_jw.
and log(H_jw) not log*H_jw
Mathcad works top to bottom, and left to right. Everything must be defined in the right sequence. So you can't set 'rc' until R and C are defined (move them above).
And RC is not the same as R*C.
And don't define H(jw) like that. You're creating a function of jw but there is no jw there. Just call it H or H_jw.
and log(H_jw) not log*H_jw
Thank you very much .
Your answer will help me a lot
Concerning RC and R or C in my equations RC is not the same as R*C , it's a new number .
I'll try it all out , thank you
Marco