Setting up CreateSpace correctly?

[pquint]

Greetings,

I had created a test document to practice the CreateMesh and CreateSpace functions.

This was done on one machine with Mathcad 15.

Now, the CreateSpace will not  display on a different machine which also has Mathcad 15 and Prime 3.1.

Any ideas as to why?

If nothing is wrong with the set-up, what settings could make this behavior happen?

The file is attached.

Thank you for your time.

P. Quint

[AndyWesterman]

It might be a problem with the monitor set-up,  I took the following snips from the same laptop just set either for 16bit or 32bit colour resolution.

regards

   Andy

[VladimirN · Accepted solution]

Right click on 3D plot (created by using "CreateSpace") and deselect "Border".

[pquint]

Thanks VladimirN.

I don't know why that enabling the border messes with the display, but yeah.

Mark

[VladimirN]

You're welcome.

Peter Quint wrote:

...

I don't know why that enabling the border messes with the display...

The problem with the border for 3D plot - it is an old story.