On 4/1/2009 4:23:14 AM, Jbryant61 wrote:
>Can anyone offer advice on how
>to transform one data set into
>another.
>
>Thanks
>Jason
__________________________
The 1/1 replace part of, is the immediate approach. If you then want to remove noise (filter), the question is to be evaluated by experimenting: before or after replacing ? also it means experimenting lot of filters, like Fourier windows... etc... before/after replacing. The filter may not be available in Mathcad.
Attached is the red right leg smoothed ksmooth bw = 9
Not bad at all as it preserves the principal ondulation, that you can adjust by bw (bandwidth of the ksmooth). That's as far I understand matching. Remember: splining noisy data set is disaster, it means wrongly understanding and using splines.
You can apply the same technique on the left leg, not done. Conclusion: the april 1rst virus, was too small fish to fry ! There was a warning here on the news. Lots of peoples got little birds flying across the screen, not as bad as Peddy the Parrot from Richard !
Salut Jason, Jean.