Community Tip - When posting, your subject should be specific and summarize your question. Here are some additional tips on asking a great question. X
Hello All,
I am generating values for DEFORM FEA software to determine a sinusoidal motion.
My current method is to develop the function for my motion in Mathcad, then take the variable value and transplant it into Excel. From Excel I can copy and paste into my DEFORM table.
I would like grab the values directly from Mathcad.
Any suggestions would be appreciated!
Thanks,
Don
Solved! Go to Solution.
Two things that would at least simplify what you are doing are:
1.) WRITEEXCEL. would dump the data into excel right where you want it
2.) Add an Excel component. Then you could cut/paste easier.
But I don't think you can avoid excel (unless deform accepts txt, csv or prn - which mathcad can also write.
Two things that would at least simplify what you are doing are:
1.) WRITEEXCEL. would dump the data into excel right where you want it
2.) Add an Excel component. Then you could cut/paste easier.
But I don't think you can avoid excel (unless deform accepts txt, csv or prn - which mathcad can also write.
This worked great once I activated the full license.