What is the difference between Prime and Machcad 15
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
What is the difference between Prime and Machcad 15
Hello
What is the difference between Prime and Machcad 15, because the function works in 15, but in Prime does not work.
And also there is a possibility that Pime read M 15.!
greetings
Solved! Go to Solution.
- Labels:
-
Other
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
It works when I try it in Prime 3.0:
What's the error message?
Prime can convert Mathcad 15 files, but not read them. See the input/output tab. You need to have Mathcad 15 installed, and the converted worksheet may not work, and may need editing.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
bens djel написал(а):
Hello
And also there is a possibility that Pime read M 15.!
greetings
You must use the convertor in Prime to convert xmcd into mcdx format.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
It works when I try it in Prime 3.0:
What's the error message?
Prime can convert Mathcad 15 files, but not read them. See the input/output tab. You need to have Mathcad 15 installed, and the converted worksheet may not work, and may need editing.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Looks like you used a literal subscript (Ctl+-) where you should have used a matrix index ([) for fi.
Note the difference between the two in the following example:
The literal subscript returns the error shown.
Visually, the matrix index is lower than the literal subscript.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
thanks a lot for your help