Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
i am trying to program ;this routine (that i picked up from another topic here, originally written in mathcad 15) to calculate the depth to the midpoint of each layer. the results for z should be 4.5, 13.5, 22.5, 31.5, 40.5.
any assistance would be appreciated. the file is in mathcad 4.0
Solved! Go to Solution.
And here is what you probably were trying to do
that works! thank you very much.