I had got an error while performing static simulation

[RN_10004064]

Hello community members,

I had got an error while performing static simulation. Could you please help me from this problem

Error stating " 

The design study terminated abnormally.
The model is insufficiently constrained for the analysis.
Please review the element connections, properties, and
constraints. If this is a modal analysis, then you may
be able to obtain a solution by requesting additional
modes."

i had attached image of it 

waiting for your response

Thanking......

[VladimirN]

What version of Creo Simulate are you using?

Here are some helpful articles:

• "Error: "The model is insufficiently constrained for the analysis...": https://www.ptc.com/en/support/article/CS39219
• "The model is insufficiently constrained for the analysis. Please review the element connections, properties, and constraints..": https://www.ptc.com/en/support/article/CS124738
• "Assembly contact analysis fails with message “The model is insufficiently constrained for the analysis” in Pro/MECHANICA Wildfire": https://www.ptc.com/en/support/article/CS32467
• "Troubleshooting errors in Creo Simulate": https://www.ptc.com/en/support/article/CS261374

Also, there were similar questions before: 

• "Static analysis failed due to unconstrained model": https://community.ptc.com/t5/Analysis/Static-analysis-failed-due-to-unconstrained-model/td-p/726014
• "Creo 1.0 Simulate Issue - "Model is insufficiently constrained": https://community.ptc.com/t5/3D-Part-Assembly-Design/Creo-1-0-Simulate-Issue-quot-Model-is-insufficiently-constrained/td-p/365225

[RN_10004064]

i am using creo simulate 7.0