cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

RE: Upgrading from Creo 2.0 M010 to M020

PaulSpencer
7-Bedrock
7-Bedrock
‎Nov 18, 2012 06:37 PM
‎Nov 18, 2012 06:37 PM

RE: Upgrading from Creo 2.0 M010 to M020

Hi

I'd like to upgarde from Creo 2.0 M010 to release M020 - ho do I go about doing this?

In anticipation

Thanks

Paul Spencer

0 Kudos
Notify Moderator
2 REPLIES 2
TimBrotherhood
12-Amethyst
12-Amethyst
(To:PaulSpencer)
‎Nov 19, 2012 04:12 AM
‎Nov 19, 2012 04:12 AM

Always uninstall all previous versions including Quality Agent then do a clean install. You should be able to use your existing Creo 2 product code.

Hang for until I send you M030 download link, the config.pro has been updated to sort a problem with WindowsXP 32 bit. The Choice DOS command got missed off.

0 Kudos
Notify Moderator
PaulSpencer
7-Bedrock
7-Bedrock
(To:TimBrotherhood)
‎Nov 19, 2012 03:10 PM
‎Nov 19, 2012 03:10 PM

OK Tim , will do. Any time scale to this?

0 Kudos
Notify Moderator
Announcements
Contact Community Management
Top Tags