installation creo 7.08 student edition; license request failed for feature

[ED_10492786]

Hello All,

After Installing creo7.08 student editon according installation guide I recieved error "license request failed for feature"

In parallel I recieved an sw license email prt email. But what to do with this package? How to install this?

I hope, somebody could help.

Kind regards

Figolino

[VladimirN]

 Hi,

There was a similar question before:

• "License request failed for feature Creo 7.0": https://community.ptc.com/t5/PTC-Education-Forum/License-request-failed-for-feature-Creo-7-0/td-p/813667 
• "Creo 7.0.0.0 student version error "License request failed for feature"": https://community.ptc.com/t5/PTC-Education-Forum/Creo-7-0-0-0-student-version-error-quot-License-request-failed/m-p/700585 

[MartinHanak]

---

@ED_10492786 wrote:

Hello All,

After Installing creo7.08 student editon according installation guide I recieved error "license request failed for feature"

In parallel I recieved an sw license email prt email. But what to do with this package? How to install this?

I hope, somebody could help.

Kind regards

Figolino

---

Hi,

please upload license. I will check its contents and give you an advice what to do.

[ED_10492786]

Hello Martin, thank you for your support! See enclosed as requested  licence email. I covered my email and contact data with xxx. I am looking forward to your hints to solve the problem. 

[MartinHanak · Accepted solution]

---

@ED_10492786 wrote:

Hello Martin, thank you for your support! See enclosed as requested  licence email. I covered my email and contact data with xxx. I am looking forward to your hints to solve the problem. 

---

Hi,

to resolve your problem, you have to edit parametric.psf file located in Parametric\bin subdirectory. In my Creo 7.0.9.0 installation the path to the file is E:\PTC\Creo7_090\Creo 7.0.9.0\Parametric\bin\parametric.psf.

Save sw_license_email_84994mod.txt for example into C:\Temp directory (you can save it into any other directory).

Open parametric.psf file in Notepad, locate following lines, check/modify their contents and save the file.

ENV=PTC_D_LICENSE_FILE-=C:\Temp\sw_license_email_84994mod.txt
ENV=CREO_APP=PMA
ENV=CREOPMA_FEATURE_NAME=CREOPMA_SchoolSTD6 ()

Important note:

Your license file is generated for network card with MAC address 6C-C2-17-78-4D-45. This network card must be alive when you start Creo. You can open Command prompt window and run ipconfig /all command to check, whether the network card is available.

[ED_10492786]

Hello Martin,
thank you very much!

Your guide worked well to solve my installation problem.

👍