Rectangular pipes in spec driven piping?

[mschubert-2]

Hi,

Does anybody know how to add rectangular pipes to a piping spec?

I tried to add second values to the size params in pipe_[spec].ptd and/or od_[spec].ptd, so far without result.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[jsarkar]

Look at this TPI 137516, it says square pipe may be possible.

[mschubert-2 · Accepted solution]

Thanks for the quick response, this was just what I needed

Creo's online help wasn't exactly clear on how to combine two sizes:

In pipe_[spec].ptd one needs to put both sizes within quotation marks and connect them with an X, e.g.:

"SCH_RATE" "SIZE" "END_TYPE"

"10" "H055" "BW"

"10" "B050" "BW"

"10" "H055XB050" "BW"

(Note: "heightXwidth")