I´m trying to apply moment to a part but the menu to select "total load at point" is not available. I checked it with my colleagues where it works but on my workstation/installation/config it is not shown.
Any idea?
Problem solved 
FEM Mode was selected
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
