It doesn't appear as though Creo is paying attention to my pen table file when exporting to pdf.
The config editor shows that the config option is loaded:
[cid:image001.png@01CDDF8A.C47E60F0]
And I have use pen table checked in the setup dialog:
[cid:image002.png@01CDDF8A.C47E60F0]
But the line weights in the pen table file are ignored.
One other question. Anyone know where a saved profile is saved to? Notice in the screen shot above pdf_mono is the profile I saved.
David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
