cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Your Friends List is a way to easily have access to the community members that you interact with the most! X

Creo Config File Issue

dgschaefer
21-Topaz II

Creo Config File Issue

I noticed this week that PTC marked the SPR related to saving multiple
config files [1] resolved in Creo 2 M030, due later this month, which
was expected.



What wasn't expected is it's also marked as resolved in Creo 1 M050,
which has been out since the beginning of last month. I didn't think it
was going to be resolved in Creo 1 at all.



Since this was a bit of a deal breaker, or at least a source of
frustration, for many I thought I'd let folks know.



[1] - https://www.ptc.com/appserver/cs/view/spr.jsp?n=2095844
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
--
Doug Schaefer | Experienced Mechanical Design Engineer
LinkedIn
1 REPLY 1

I downloaded Creo 1.0-m050 and installed it so I could check the behavior of the config editor.


1. I can view specific config files

2. When I try to edit a specific config and save, it saves everything to the config file.

So in my opinion, it's not fixed properly. I don't know what TC dealt with PTC on this but I believe they didn't communicate clearly what is required. It's still broken.

What I did:
Open the config editor
Select from the pull down the config.sup
[cid:image001.png@01CDBE52.A0E57380]

It now shows me only the config.sup. That is a big improvement!

[cid:image002.png@01CDBE52.A0E57380]

I next pick the Add... button and the Find... button search for something and added it to the config.

[cid:image003.png@01CDBE53.2EC29700]

So far, so good. Looking like I expect it to work.

I pick OK, the only button that looks like it will save my edit for me.
I get this message:
[cid:image004.png@01CDBE53.801C1720]

I believe the correct answer is Yes
In the save dialog, I had to browse to the loadpoint. And then it would not show me the existing config.sup so I had to type the name in manually.

[cid:image006.png@01CDBE54.9647F180]

I then go back to the config editor to look at the config.sup again and I see this:
[cid:image005.png@01CDBE55.53DB7000]

My new option was at the end of the file.


David Haigh
Top Tags